Error
  • The chosen template couldnt find on the filesystem: Evolution Oil Tools

SLPX Blanking Plug

The Evolution Model SLPX Blanking Plug is used to land into the appropriate sized Model SLX Landing Nipple. Once in place it blanks off all pressure from above or below the tool. Some of the uses for the SLPX are: to pressure test tubing, to temporarily isolate specific zones the well, to temporarily or permanently suspend or abandon selected zones of the well and to help snub tubing into or out of the hole under pressure.
Description

ER Landing Nipple TDS

SLPX Blanking Plug
Technical Data Sheet

Landing and blanking SLX Nipples

 


Applications

 

  • Pressurizing test tubing
  • Zone isolation
  • Temporary or permanent suspend or abandon zones
  • Snubbing in under pressure

Features

 

  • Works to plug SLX Landing Nipples
  • Reliable design


SLPX Blanking Plug







The Evolution Model SLPX Blanking Plug is used to land into the appropriate sized Model SLX Landing Nipple.

Once in place it blanks off all pressure from above or below the tool.  Some of the uses for the SLPX are: to pressure test tubing, to temporarily isolate specific zones the well, to temporarily or permanently suspend or abandon selected zones of the well and to help snub tubing into or out of the hole under pressure.

 

Operation

 

Running Pressure

1. Attach the SLPX to the Model SLX Running Tool.

2. Run the tool string just below the SLX Nipple where the plug is to be set.

3. Raise the tools until the locating dogs on the running tool locate on the bottom of the nipple.  Pull upward to trip the locating dogs.  This places the running tool in the control position.

4. Lower the tool string back down until the keys on the SLPX locate into the locking grooves of the SLX Landing Nipple.

5. Once located, jar downward to drive the Expander Sleeve firmly behind the keys.  Jar upward to shear the lower pin in the running tool.

6. Retrieve the tool string from the hole.

7. Run the equalizing prong and land it into the plug body. Shear off and remove the tool string from the hole.

 

*If there is no other nipple in the well, open the SLX Running Tool into the control position at surface.  Once done run the tools as described in steps 6 and 7 above

Pulling Procedure

1. Run in with a Model EGR Pulling Tool.  Latch onto, and jar upward as required, and retrieve the Equalizing Prong from the plug body.

2. Allow sufficient time for full pressure equalization.

 

3. Once equalization has taken place, run in with a Model ERG Pulling Tool.  Latch into the fishing neck. Jar upward.  This action moves the Expander Sleeve upward, freeing the keys. Jar upward to remove the plug body from the nipple.

SLPX Blanking Plug

 

SLPX Blanking Plug

 

 

 

 

 

 

Tags - Flow Control, EOT, Evolution Oil Tools, blanking plug, SLPX Blanking Plug, SLX, SLX Landing Nipple

 

 

Fill out my online form.